Help Centre

Wiring our single pole in-line switch

The Arditi single pole in line table lamp switch is a small and neat looking lamp switch. However making it small can cause a few assembly issues when wiring these switches. It’s a case of take your time to make a neat wiring job.

  1. Remove the twp screws from the back.
  2. Remove the 4 cable clamp screws and straps
  3. Strip the cables to the following lengths:
    Live: 12mm | Neutral: 29mm | Earth: 29mm
  4. Strip 8mm off the end of each cable, twist
    then double over the wire to 4mm.
  5. Wire the switch as per the image below.
  6. Install cable clamps and switch cover to finish.

Note: If the metal tab have fallen out of your switch bodt then view this guide