Help Centre

Assembly and wiring of our black twin inline foot switch

This is a quick step-by-step guide on how to assemble and wire our black twin inline foot switch. In this example, i will be showing you how to wire this twin switch using 1x feed and 2x outputs. Any electrical work should be carried out by a competent person. This switch comes in pieces and consists of the following items:

  1. This switch comes in pieces and consists of the following items:
    1. Back Body
    2. Front Body
    3. Body Screws
    4. Neutral Block
    5. Switches
    6. Switch Covers
  2. Take the neutral block and place it into the centre of the switch body.
  3. Wire the switches as show below. This configuration of wiring is 1 feed and 2x outputs, you can have 2 separate feed and 2 output if you wish. Feed is the bottom cable and the 2x outputs are the 2 cable at the top.
  4. Once wired, and you are happy with the connections and configurations, place the cord grips over the cables then using the screws, screw them down to hold the cables into a firm position.

    Finally place the switch caps onto of the switches.

  5. Once the caps are resting on top, carefully place the top cover over the top, note the cover will only go one way as the switches are off-centre slightly.
  6. Finally, flip the unit over and place and tighten the 2x cover screw into position.